Filter
Top Products
2712 CHAPTER 179: VOFR CONFIGURATION COMMANDS
[Sysname-voice-dial] entity 4 vofr
[Sysname-voice-dial-entity4] match-template 12345
[Sysname-voice-dial-entity4] address vofr-dynamic serial1/0 100
call-mode
Syntax call-mode { dynamic | static }
undo call-mode
View VoFR entity view
Parameter dynamic: Adopts the dynamic call mode.
static: Adopts the FRF.11 trunk mode.
Description Use the
call-mode command to configure the mode in which calls between the
VoFR entity and the peer voice entity are established.
Use the
undo call-mode command to restore the default call mode.
By default, the dynamic mode is adopted.
n
■ Dynamic call mode: When a call is originated, the frame relay will randomly
select an idle FRF.11 sub-channel to establish a voice channel. After the call is
completed, the frame relay will immediately remove the voice channel and
release the corresponding FRF.11 sub-channel. The call control protocol used in
the dynamic call mode is specified by executing the vofr command in interface
DLCI view.
■ FRF.11 trunk mode: A voice channel is established when you execute the
address vofr-static command. The voice channel is directly used to establish
calls. After the call is completed, the voice channel remains until it is manually
cleared. In the FRF.11 trunk mode, you must use the trunk-id command to
configure a PSTN-dialed number for the terminating VoFR entity.
Related command: trunk-id and address.
Example # Configure the FRF,11 trunk mode for VoFR entity 10.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 vofr
[Sysname-voice-dial-entity10] call-mode static
cid select-mode
Syntax cid select-mode { max-poll | min-poll }
undo cid select-mode