Filter
Top Products
228 CHAPTER 13: FUNDAMENTAL CT1/PRI INTERFACE CONFIGURATION COMMANDS
When creating a PRI set on a CT1/PRI interface, note that timeslot 24 is the D
channel for transmitting signaling; it cannot form a bundle that includes itself only.
The attempts to bundle only timeslot 24 will fail.
In the created PRI set, timeslot 24 is used as D channel for signaling transmission,
and the other timeslots as B channels for data transmission. You may randomly
bundle these timeslots into a PRI set (as the D channel, timeslot 24 is automatically
bundled). If no timeslot is specified, all timeslots are bundled into an interface
similar to an ISDN PRI interface in the form of 23B+D.
For the PRI set, the system automatically creates a serial interface logically
equivalent to an ISDN PRI interface. The serial interface is named in the form of
serial number:23, where number is the number of the CT1/PRI interface on which
the serial interface is created.
Because a channel set and a PRI set cannot coexist on a CT1/PRI interface, your PRI
set creation attempt will fail if the channel-set command is configured.
Example # Bundle timeslots 1, 2, and 8 through 12 into a PRI set on CT1/PRI interface T1
2/0.
<Sysname> system-view
[Sysname] controller t1 2/0
[Sysname-T1 2/0] pri-set timeslot-list 1,2,8-12
reset counters controller t1
Syntax reset counters controller t1 interface-number
View User view
Parameter interface-number: Interface number.
Description Use the
reset counters controller t1 command to clear the controller counter
for a CT1/PRI interface.
To display the value of the controller counter, use the display controller t1
command.
n
The reset counters interface command cannot clear the controller counters for
CT1/PRI interfaces. To do so, you must use the reset counters controller t1
command.
Example # Clear the controller counter for CT1/PRI interface T1 2/0.
<Sysname> reset counters controller t1 2/0