Filter
Top Products
346 CHAPTER 21: BASIC DLSW CONFIGURATION COMMANDS
[Sysname] dlsw reachable saps 12 14
# Permit access to user-configured MAC addresses only.
[Sysname] dlsw reachable mac-exclusivity
dlsw reachable-cache
Syntax dlsw reachable-cache mac-address remote ip-address
undo dlsw reachable-cache mac-address remote ip-address
View System view
Parameter mac-address: MAC address of the SNA device connected to a remote peer.
ip-address: IP address of a remote peer.
Description Use the
dlsw reachable-cache command to add the reachability information of
the specified SNA device to the reachable-cache.
Use the
undo dlsw reachable-cache command to remove the configured
remote reachability information from the reachable-cache.
By default, no remote reachability information is configured.
This configuration allows the router to send frames to a remote peer without first
polling it. When changes occur to the network of the remote peer, the configured
reachability information needs to be updated.
Example # Add this remote reachability information to the reachable-cache: the IP address
of the remote peer is 10.12.13.10, and the MAC address of the SNA device
connected with it is 0102-2103-5641..
<Sysname> system-view
[Sysname] dlsw reachable-cache 0102-2103-5641 remote 10.12.13.10
dlsw remote
Syntax dlsw remote ip-address [ backup backup-address | keepalive keepalive-interval |
linger minutes | max-frame max-frame-size | max-queue max-queue-length | priority
priority ] *
undo dlsw remote ip-address
View System view
Parameter ip-address: IP address of the remote peer to be created.