Filter
Top Products
665
4 packets input, 50 bytes, 0 drops
4 packets output, 50 bytes, 0 drops
Refer to Table 117 for the description on the fields of the display interface
virtual-access command.
interface
Syntax interface interface-type interface-number.subnumber [ p2mp | p2p ]
undo interface interface-type interface-number.subnumber
View System view
Parameter interface-type interface-number.subnumber: Interface type and interface number.
The interface-number argument is the primary interface number, and the
subnumber argument is the sub-interface number, ranging from 0 to 1023.
p2mp: Configures the type of a WAN sub-interface to be point-to-multipoint.
p2p: Configures the type of a WAN sub-interface to be point-to-point.
Description Use the
interface interface-type interface-number.subnumber [ p2mp | p2p ]
command to create a WAN sub-interface and enter WAN sub-interface view.
Use the
undo interface command to remove the specified sub-interface.
Currently, point-to-multipoint or point-to-point sub-interfaces can be configured
for ATM interfaces, frame relay interfaces or X.25 interfaces. By default,
point-to-multipoint sub-interfaces are created.
A Layer 3 Ethernet interface can accommodate 1 to 4,096 sub-interfaces.
Example # Create a sub-interface on ATM 2/0.
<Sysname> system-view
[Sysname] interface atm 2/0.1
[Sysname-Atm2/0.1]
interface ethernet
Syntax interface ethernet interface-number.subnumber
undo interface ethernet interface-number.subnumber
View System view
Parameter interface-number.subnumber: Interface number. The interface-number argument
is the primary interface number, and the subnumber argument is the sub-interface
number, ranging from 1 to 4094.