Filter
Top Products
317
With both references configured, the device always attempts to place return calls
in the user reference approach and in case failure occurs the dial number reference
approach. If the command is configured with neither keyword, it equals the dialer
callback-center user dial-number command.
Related command: ppp callback in PPP Commands in Access Volume.
Example # Specify the device as the PPP callback server, and set the callback reference to
user mode.
<Sysname> system-view
[Sysname] interface serial2/0
[Sysname-Serial2/0] ppp callback server
[Sysname-Serial2/0] dialer callback-center user
[Sysname-Serial2/0] dialer route ip 1.1.1.2 user Sysnameb 8810052
# Specify the device as the PPP callback server, and set the callback reference to
dial number mode.
<Sysname> system-view
[Sysname] local-user usera
[Sysname-luser-usera] password simple usera
[Sysname-luser-usera] service-type ppp
[Sysname-luser-usera] service-type ppp callback-number 8810048
[Sysname-luser-usera] quit
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ppp callback server
[Sysname-Serial2/0] dialer callback-center dial-number
dialer call-in
Syntax dialer call-in remote-number [ callback ]
undo dialer call-in remote-number [ callback ]
View Dial interface (physical or dialer) view
Parameter remote-number: Used for matching ISDN calling numbers. The asterisks (*)
represent any characters.
callback: Enables the device to place a return call if an incoming number matches
the number specified by the remote-number argument.
Description Use the
dialer call-in command to configure a valid ISDN calling number and
with the callback keyword to enable callback for the number.
Use the
undo dialer call-in command to remove the setting.
By default, ISDN callback is disabled.