Filter
Top Products
Features
120
NS9750 Hardware Reference
8 More boot, initialization, or application code is executed.
Example: Boot from flash, SDRAM remapped after boot
The system is set up as:
Chip select 1 is connected to the boot flash device.
Chip select 4 is connected to the SDRAM to be remapped to 0x00000000 after
boot.
The boot sequence is as follows:
1 At power-on, the reset chip select 1 is mirrored into chip select 4 (and chip
select 0). The following signals are configured so the nonvolatile memory device
can be accessed:
– boot_strap[4:3]
– gpio[49]
2 When the power-on reset (reset_n) and AHB reset (HRESETn) go inactive, the
processor starts booting from
0x00000000 in memory.
3 The software programs the optimum delay values in flash memory so the boot
code can run at full speed.
4 The code branches to chip select 1 so the code can continue executing from the
non-remapped memory location.
5 The appropriate values are programmed into the memory controller to configure
chip select 4, and the memory device is initialized.
6 The address mirroring is disabled by clearing the address mirror (M) field in the
Control register (see page 205).
7 The ARM reset and interrupt vectors are copied from flash memory to SDRAM
that can then be accessed at address
0x00000000.
8 More boot, initialization, or application code is executed.