Filter
Top Products
Registers
214
NS9750 Hardware Reference
Dynamic Memory Active to Precharge Command Period register
Address: A070 0034
The Dynamic Memory Active to Precharge Command Period register allows you to
program the active to precharge command period, t
RAS
. It is recommended that this
register be modified during system initialization, or when there are no current or
outstanding transactions. Wait until the memory controller is idle, then enter low-
power or disabled mode. This value normally is found in SDRAM datasheets as t
RAS
.
Note:
The Dynamic Memory Active to Precharge Command Period register is
used for all four dynamic memory chip selects. The worst case value for
all chip selects must be programmed.
Register bit assignment
Bits Access Mnemonic Description
D31:04 N/A Reserved N/A (do not modify)
D03:00 R/W RAS Active to precharge command period (t
RAS
)
0x0–0xE
n+1 clock cycles, where the delay is in CLK cycles.
0xF
16 clock cycles (reset value on reset_n)
Table 145: Dynamic Memory Active to Precharge Command Period register
13121110987654321015 14
31 29 28 27 26 25 24 23 22 21 20 19 18 17 1630
Reserved
Reserved RAS