Filter
Top Products
Ethernet front-end module
328
NS9750 Hardware Reference
I When set, tells the TX_WR logic to set TXBUFC in the Ethernet Interrupt Status
register (see page 385) when the buffer is closed due to a normal channel
completion.
Buffer pointer 32-bit pointer to the start of the buffer in system memory. This pointer can be
aligned on any byte of a 32-bit word.
Status Lower 16 bits of the Ethernet Transmit Status register. The status is returned
from the Ethernet MAC at the end of the frame and written into the last buffer
descriptor of the frame.
L When set, tells the
TX_WR logic that this buffer descriptor is the last descriptor
that completes an entire frame. This bit allows multiple descriptors to be
chained together to make up a frame.
F When set, indicates the buffer is full. The TX_WR logic clears this bit after
emptying a buffer. The system software sets this bit as required, to signal that
the buffer is ready for transmission. If the
TX_WR logic detects that this bit is
not set when the buffer descriptor is read, it does one of two things:
If a frame is not in progress, the TX_WR logic sets the TXIDLE bit in the
Ethernet Interrupt Status register.
If a frame is in progress, the TXBUFNR bit in the Ethernet Interrupt Status
register is set.
In either case, the
TX_WR logic stops processing frames until TCLER (clear
transmit logic) in Ethernet General Control Register #2 is toggled from low to
high.
TXBUFNR is set only for frames that consist of multiple buffer descriptors and
contain a descriptor — not the first descriptor — that does not have the F bit set
after frame transmission has begun.
Buffer length This is a dual use field:
When the buffer descriptor is read from the TX buffer descriptor RAM,
buffer length indicates the length of the buffer, in bytes. The
TX_WR logic
uses this information to identify the end of the buffer. For proper operation
of the
TX_WR logic, all transmit frames must be at least 34 bytes in length.
When the TX_WR logic updates the buffer descriptor at the end of the
frame, it writes the length of the frame, in bytes, into this field for the last
buffer descriptor of the frame.
If the MAC is configured to add the CRC to the frame (that is, CRCEN in
MAC Configuration Register #2 is set to 1), this field will include the four
bytes of CRC. This field is set to 0x000 for jumbo frames that are aborted
(see "TXAJ" on page 346)
Only the lower 11 bits of this field are valid, since the maximum legal frame size
for Ethernet is 1522 bytes.
Field Description