Filter
Top Products
USB host block registers
734
NS9750 Hardware Reference
Register bit assignment
Bits Access Mnemonic Reset Description
D31 N/A Reserved N/A N/A
D30 R/W OC 0b OwnershipChange
Set by the host controller when the host controller driver
sets the OwnershipChangeRequest field in the
HcCommandStatus register (see "HcCommandStatus
register," beginning on page 730). This event, when
unmasked, always generates a system management
interrupt (SMI) immediately.
This bit is tied to 0b when the SMI pin is not implemented.
D29:07 N/A Reserved N/A N/A
D06 R/W RHSC 0b RootHubStatusChange
Set when the content of the HcRhStatus register (see
"HcRhStatus register," beginning on page 756) or any
HcRhPortStatus[NumberofDownstreamPort] register (see
"HcRhPortStatus[1] register," beginning on page 759) has
changed.
D05 R/W FNO 0b FrameNumberOverflow
Set when the most significant bit (MSB), bit 15, of the
HcFmNumber (see "HcFmNumber register," beginning
on page 749) changes value, from 0 to 1 or 1 to 0, and after
HccaFrameNumber has been updated.
D04 R/W UE 0b UnrecoverableError
Set when the host controller finds a system error not
related to USB. The host controller should not proceed
with any processing nor signaling before the system error
has been corrected. The host controller driver clears this
bit after the host controller has been reset.
D03 R/W RD 0b ResumeDetected
Set when the host controller finds that a device on the USB
is asserting resume signaling. The transition from no
resume signaling to resume signaling causes this bit to be
set.
This bit is not set when the host controller driver sets the
USBRESUME state.
Table 426: HcInterruptStatus register