Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-446DIG-LINE (Digital Line)
10
Digital Station Audits Test (#17)
This is a series of six tests which are classified as audits. The SPE sends
messages to the on-board microprocessor to perform the following tests. These
audits run only if the station is in-service.
■ Switchhook Inquiry Test — This is an update of the SPE records
according to the circuit pack’s records. This inquiry is sent all the way to
the voice terminal.
■ Bad Scan Inquiry Test — A message is sent uplink which contains a
count that is generated due to certain events relating to the link conditions.
This can be an indication of communications problems between the
Processor and Digital Port circuit pack.
■ EPF/PTC Inquiry Test — For a TN413 or a TN754 vintage 13 or earlier, the
status of the Electronic Power Feed (EPF) is sent uplink. Possible
conditions are: EPF-on-ok, EPF-off, and EPF-no-load. For TN754 vintage
14 or later, TN754B or TN2136, TN2181, TN2224, the status of the Positive
Temperature Coefficient (PTC) is sent uplink. Possible conditions are:
PTC-on-ok, PTC-off, and PTC-no-load.
■ ID Request Test — A request is made to the station for its status. The
station sends its configuration information and health information back.
This information is checked and a pass/fail result is provided.
■ Ringer Update Test — This updates the digital telephone ringer state
according to the processor records.
FAIL Internal System Error
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, escalate the problem.
PASS The message to light all of the station lamps was sent successfully to the
port.
1. Observe the station lamps being lit when running the test. If all lamps
do not light successfully, the other Digital Line test results may
indicate related problems that will not allow the lamps to light.
2. Investigate by using other Digital Line port tests, and by examining the
station, wiring, and connections.
Table 10-146. TEST #16 DIG-LINE Station Lamp Updates Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page