Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1420TONE-PT (Tone Generator)
10
Tone Generator Crosstalk Test (#90)
This test checks the ability of the Tone Generator to talk on a specific time slot.
The tone generator is told to talk on a specific time slot. The other idle time slots
are checked to make sure the Tone Generator put the tone on only the specified
time slot.
2 FAIL The system requires TN2182 tone-clocks to support the currently
administered country-options tone generation parameters.
1. Check the administration on the system-parameters country-option
form. Specifically, the Base Tone Generation Set on page 1 and any
custom tone administration beginning on page 2.
2. Replace existing tone-clock circuit packs with TN2182s.
PASS The tone generation facility has been successfully refreshed with its
time-slot translation and system administration is consistent with this type
of tone-clock.
1. Display the Hardware Error Log via the display errors command to
make sure this circuit pack did not generate new errors.
2. If errors persist, follow normal escalation procedures.
Table 10-486. TEST #90 Tone Generator Crosstalk Test
Error
Code
Test
Result Description/ Recommendation
None ABORT Internal System Error
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, follow normal escalation procedures.
1001 ABORT The system was not able to put the tone generation facility in the
appropriate mode to test it.
1002 ABORT The system could not allocate time slots for the test connection. This can
happen when the system is heavily loaded. If the system is not heavily
loaded, then test the TDM-BUS via the test tdm port-network PN#
command. Refer to TDM-BUS section for details.
Continued on next page
Table 10-485. TEST #41 Tone Generator Update/Audit Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page