Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-52display communication-interface
8
The display comm hop-channels command displays the translation data for
hop channels. A hop channel is a bi-directional network channel between two
interface links for DCS message hopping. A hop channel is used to tandem DCS
messages from one interface link to another interface link.
The display communication-interface links command displays the translation
information for each communication interface link. A link is an electronic
communication channel transmitted over the Packet Bus for carrying
packet-switched data. There are 16 links that terminate at one end on the Packet
Interface circuit pack in the SPE. At the physical and link layers, the link
terminates at the other end on a port on the PBX’s switching matrix. At a higher
level, the link continues over a transmission facility to another endpoint, such as a
DCS node or AUDIX. The link carries application messages between the SPE
and other switches or adjuncts.
The display comm processor-channel command displays the translation
information for each of the local processor channels. A processor channel is one
several data streams which are multiplexed by the X.25 protocol onto a single
data link. The system has 128 total processor channels; up to 64 can be
assigned to a single link.
See also ‘‘
status link’’ for more details.
Output for Hop-channels qualifier
When you enter the command display comm hop, the systems displays the Hop
Channel Assignment screen, similar to the figure below. The number of the local
processor channel, used to hop the interface link channels, is not shown.
1. Refer to the Report Scheduler and System Printer feature specification for more details.
Action/Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
display
communication-
interface
hop-
channels
links
processor-
channel
print|
schedule
See above
See above
See above
Report sent to printer
Command is validated and then a
scheduling form displays to
schedule execution of the
command. The command is then
placed in the command queue
and is executed at the specified
time. The information displayed
by the command is sent to the
system printer instead of the
screen.
1
init
inads
craft
cust
rcust
none none