Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-661FL-DATA (Flash Data Consistency)
10
35514 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
35534 ABORT Could not allocate the (active or standby) memory card drive because
another memory card operation was in progress.
1. Wait 10 minutes, and retry the command.
35535 ABORT Could not access the (active or standby) memory card.
1. The memory card may be damaged or missing. Resolve all
problems with all memory card tests in the Long Test Sequence
for both memory cards.
2. Repeat the test.
1 FAIL The standby translations are out-of-date. The translations on the
Standby SPE (memory card) are older than those on the Active SPE
(memory card).
2 FAIL The Active SPE translations are out-of-date.
1. Issue save translations command. If the translation save passes
on both SPEs, go to Step 2.
2. Run test card-mem long again to resolve the alarms.
4 FAIL The load vintages are different in both SPEs.
1. Determine the desired software release by issuing the list
configuration software long command. Obtain the memory card
of the same software release. Follow the upgrade software
procedure to upgrade the out-of-date SPE.
2. Run the test card-mem long command again to resolve alarms.
5 FAIL The load vintages and translations are different in both SPEs. The
Active SPE has the most current translations.
1. Follow the procedures for Error Code 4.
6 FAIL The load vintages and translations are different in both SPEs. The
Standby SPE has the most current translations.
1. Follow the procedures for Error Code 4.
2. Issue the save translations command. If the translation save
passes on both SPEs, proceed to Step 3.
3. Run the test card-mem long command again to resolve alarms.
Table 10-223. TEST #421 Flash Data Consistency Check Test — Continued
Error Code
Test
Result Description/Recommendation
Continued on next page