Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Routine Maintenance Procedures
Page 5-16System Backup
5
Enter the save announcements command to save the recorded announcements
in the system on the translation card.
NOTE:
A 10 MByte or larger translation card is required to save and restore
announcements.
The system takes about 10 minutes to complete this task. Because the terminal is
unavailable during this time, it is recommended that this command be used after
business hours. During this time period, the terminal cannot be used to
administer the system until the transfer is complete; however, all other terminals
(if provided) are allowed to perform administration procedures.
Enter the restore announcements command to restore the recorded
announcements from the translation card back into system memory. The system
takes about 22 minutes to complete this task. After completing the task, the
system performs an audit to make sure that the announcements on the
announcement circuit pack match the announcements administered in the
system.
The working copy of the announcements is stored on the announcement circuit
pack. A backup copy should be made on a 10 Mb or larger translation card. The
following procedure is used to make a backup Memory Card:
1. Remove the translation card from the Netcon circuit pack.
2. Insert the backup translation card into the Netcon circuit pack.
3. Enter the save translation command and press
Enter. This instructs the
system to take all translation information in memory and transfer it into the
translation card. The following display appears:
Screen 5-1. Save Translation — SPEA
4. Verify that the command successfully completes. If not, an error message
appears. In such a case, refer to the “Translation Card Errors” section.
save translation SPE A
SAVE TRANSLATION
Processor Command Completion Status Error Code
SPE_A Success 0
Command successfully completely
enter command: