Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-45display alarms
8
System Reboots and the Alarm Logs
The system saves the alarm and error logs to the
active
SPE memory card if any
of the following events occur:
— The save translation command is executed.
— Translations are saved as part of scheduled maintenance.
— A reboot takes place.
— The PPN is about to lose all power after having been on battery backup.
The attempt to save the alarm and error logs may be unsuccessful if the MSS is
not available.
Whenever the system reboots, the logs are restored from the SPE disk that
becomes active with the reboot. Since the logs are saved to the disk on the SPE
that was active
before
the reboot, the versions restored at reboot time may not be
current. This condition occurs if:
— The attempt to save at reboot did not succeed.
— The SPE disk that is rebooted is not the same disk to which the logs were
last saved.
In such a case, the logs do not contain the most recent errors and alarms. To
determine if the restored logs are complete, look for indications that would have
preceded the reboot.
System resets, that are less severe than a reboot, rarely affect the error and
alarm logs.
NOTE:
If the error and alarm logs contain SYSTEM errors, then use the display
initcauses command to search for information that system could
not
log
during reset operation.