Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1044PR-MAINT (Maintenance Processor [TN790 RISC Systems])
10
Aux Data. This error entry indicates that the MTP DPR Test failed and that the
Processor circuit pack should be replaced.
NOTE:
If the test is being run from a terminal other than the PPN SAT (for example,
EPN SAT, remote access, etc.), the test results are displayed on the
screen.
NOTE:
A dial-up (through the INADS port) does not display the results discussed
in the previous paragraph. However, a dial-up through data channels does
display these results.
Table 10-357. TEST #104 MTP Dual Port Ram Test
Error
Code
Test
Result Description/ Recommendation
100 ABORT The test did not complete within the allowable time period.
1. Retry the command.
1000 ABORT System software resources required for this test are not available.
1. Retry at 1-minute intervals a maximum of 5 times.
1030 ABORT This test in not run on the Standby SPE.
2000 ABORT The response to the test request was not received within the allowable time
period.
2028 ABORT System software resources required for this test are not available.
2029 ABORT Internal system error
1. Retry at 1-minute intervals a maximum of 5 times.
FAIL The dual port RAM is not functioning correctly. Communication between the
processor and MTP is lost. The system is not able to report environmental
alarms, communicate with the Standby SPE, or reboot from tape, if
necessary.
1. Retry at 1-minute intervals a maximum of 5 times.
2. If the test continues to fail, replace the Processor circuit pack.
PASS Dual port RAM is functioning. Communication exists between the Processor
circuit pack and the MTP.
Continued on next page