Lucent Technologies lucent Server User Manual


  Open as PDF
of 2392
 
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-112ANN-PT (Announcement Port)
10
1. When attempting to record an announcement, users hear the
proper record tone, but the announcement does not record (they
do not know it until the announcement is played back).
2. Performing a test board long when the circuit pack is in this state
yields the following abort codes:
Ports 1 AND 9 abort Test #206 with code 1024
Ports 1 AND 9 abort Test #205 with code 2000
Board level Tests #209 and #210 abort with code 1024
3. The save/restore announcements command times out with:
Error encountered, can’t complete request
The Announcement circuit pack lock-up can be cleared remotely by
performing a soft reset to the circuit pack:
busyout board PCSS (this command drops all calls in progress on
the Announcement circuit pack)
reset circuit pack using the reset board PCSS command
release circuit pack using the release board PCSS command
Playback Speech Memory Array (PSMA) Test
(#206)
The PSMA test checks the integrity of a playback channel’s interface to the
speech memory and the TDM Bus. The SP has an internal buffer that contains a
specific 256-byte sequence. During this test, the byte sequence is "played"
through the 140AY device onto the TDM Bus. A General Purpose Tone Detector
is used to confirm that the proper sequence was played. This test is very
important. It is the only test that actually checks an Announcement Port’s ability
to play back an announcement on the TDM Bus. If the test fails, the Tone
Detector returns the number of bytes that did not match the expected sequence.
The larger the number, the more severe the problem with that port. If this test
fails, announcements played over this port should sound corrupted.
It is the only test that actually checks an Announcement Port’s ability to play back
an announcement on the TDM Bus. If the test fails, the Tone Detector returns the
number of bytes that did not match the expected sequence. The larger the
number, the more severe the problem with that port. If this test fails,
announcements played over this port should sound corrupted.