Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-228status bri-port
8
Status Interpretation
The following table provides information on the status bri-port form.
Layer2 State:
Point-to-point signaling link layer 2 state. Valid states are
"un-assigned," "assigned," "established," "l3-established" or
"hyperactive."
■ "un-assigned" = the link is in TEI-UNASSIGN state at Layer 2.
■ "assigned" state = the link is in the AWAIT_EST (Await
Establish) state at layer 2. (If BRI endpoints support TEI
allocation procedures, they successfully execute and a TEI is
assigned to the endpoint by the switch.
■ "established" = the link is in the MF_EST_NORM (Multi-Frame
Established Normal) state at layer 2. The switch successfully
initiates the link can now exchange layer 3 frames with the
endpoint. If the endpoint does not support SPID initialization
procedures, the endpoint extension associated with the link
also displays. This is the normal state for the link in the
point-to-point wiring configuration.
■ "l3-established" = link is in the MF_EST_NORM state at layer 2
and SPID initialization procedures successfully complete.
The endpoint extension associated with the link also displays.
This is the normal state for the link in the multi-point wiring
configuration.
■ "hyperactive" = traffic on this link goes over threshold. The
link suspends and is deemed hyperactive.
Endpt Extension
Voice/data endpoint extension associated with the link if the link
is in the "established" (point-to-point configuration) or
"l3-established" (multipoint configuration) layer 2 state.
Otherwise, this field is blank.
Endpt SPID
This field displays the SPID administered on the voice/data
endpoint associated with the link. Note that this information is
displayed only if the link is in either the "established"
(point-to-point configuration) or the "13-established" (multipoint
configuration) layer 2 state. Otherwise this field is blank.
Service SPID
Indicates if the link is associated with the Service SPID. If the link
is associated with Service SPIDs, the field contains a "yes" and
the endpoint extension field is blank; otherwise, this field is blank.
Service SPID checks building wiring between the switch and the
BRI endpoint.