Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1461UDS1-BD (UDS1 Interface Circuit Pack)
10
1301 FAIL The 120A1 CSU Module is physically connected to the TN464F board on
the back of the port carrier but the
Near-End CSU Type
field on the
add
ds1
form has not been administered as
integrated
.
1. If the 120A1 CSU Module is to be used, use the
change ds1
command
to change the
Near-End CSU Type
field to
integrated
. Otherwise,
physically remove the 120A1 CSU Module from the back of the port
carrier.
2. Run the test again.
1302 FAIL Attempting to use the 120A1 CSU Module with a TN464F circuit pack that
is configured for 32-channel (2.048 Mbps) operation. The CSU Module
only works with a DS1 board configured for 24-channel (1.544 Mbps)
operation in the United States of America.
1. If the 120A1 CSU Module is to be used, physically remove the TN464F
circuit pack and reconfigure for 24-channel (1.544 Mbps) operation.
2. Reinsert the circuit pack and run the test again.
1303 FAIL The DS1 circuit pack Suffix is incorrect for CSU Module administration. The
Near-End CSU Type
field on the
add ds1
form has been administered as
integrated
but the DS1 circuit pack is not a TN464F or later suffix UDS1
board.
1. If the CSU Module is to be used, and the
Near-End CSU
type field is
set to
intergrated
to allow for CSU Module administration, remove the
circuit pack and replace with a TN464F or later suffix board.
Otherwise, use the
change ds1
command to change the
Near-End
CSU Type
field to
other
.
1310 FAIL The DS1 Board Loopback (BLB) demand test (#1209) failed.
1. Repeat the test using the
test ds1-loop PCSS
ds1/csu-loopback-tests
command.
2. If the BLB test continues to fail, then replace the TN464F circuit pack.
3) Run this test again.
Table 10-494. TEST #138 Loss of Signal Alarm Inquiry Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page