Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1110S-SYN-PT (Speech Synthesis Port)
10
Speech Synthesis DTMF Receiver Test (#163)
A series of DTMF tones are conferenced from the TDM Bus into the port’s DTMF
receiver and checked to see if the correct tones have been detected during the
correct intervals. If all the DTMF tones were detected correctly, the test passes. If
any of the tones were not detected correctly, the test fails.
Speech Synthesis DTMF Receiver Inquiry Test
(#164)
This test determines the sanity of the port’s DTMF receiver. The on-board
microprocessor tests the port’s DTMF receiver and determines if it is in a sane
(test passes) or insane (test fails) condition.
Table 10-394. TEST #163 Speech Synthesis DTMF Receiver
Error
Code
Test
Result Description/ Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of five times.
2. If the test continues to abort, escalate the problem.
1000 ABORT System resources required to run this test are not available. The port may
be busy with a valid call and therefore unavailable for certain tests. You
must wait until the port is idle (yellow LED if off) before retesting.
1. If the port is idle, retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of five times.
2. If the test continues to abort, escalate the problem.
Any FAIL DTMF tones were not detected. This type of failure may cause features
using touch-tone input to the Speech Synthesis Port to malfunction.
1. Verify that the Tone-Clock circuit pack is functioning correctly by
checking the Error Log and using the test tone-clock long command.
2. If the test fails again, replace the Speech Synthesis circuit pack.
PASS The port has detected all DTMF tones correctly. User-reported troubles
should be investigated using other tests and verifying other ports on this
circuit pack are working correctly.
Continued on next page