Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1172STBY-SPE (Standby SPE)
10
4
(cont’d.)
ABORT 6. If no error type is logged, the problem may be the carrier A Duplication
Interface circuit pack.
■ If the red LED on the carrier A Duplication Interface circuit pack is on,
replace the carrier A Duplication Interface circuit pack as described in
Chapter 6, ‘‘
Reliability Systems: A Maintenance Aid’’ and proceed with
Steps 7, 8, and 9.
■ If the red LED on the carrier A Duplication Interface circuit pack is not
on AND if this is the first attempt to clear the problem, replace the
carrier A Duplication Interface circuit pack as described in Chapter 6,
‘‘Reliability Systems: A Maintenance Aid’’ and proceed with Steps 7, 8,
and 9.
■ If the LED is not on AND if this is the second attempt to clear the
problem (that is, the carrier A Duplication Interface circuit pack has
been replaced), escalate the problem.
7. Issue the refresh spe-standby command to put the Standby SPE into
Standby Mode. This command may have to be issued multiple times. If the
refresh spe-standby command successfully completes five times without
the Standby SPE becoming labeled "standby" on the status system form,
wait 20 minutes. This does not include cases where the command
completes with the terminal message line errors "Refresh not successful;
use ‘display errors’ to check for STBY-SPE errors" or "Cannot interrupt
Standby SPE while entering maintenance mode; please try later." Issue the
refresh spe-standby command once more. If the Standby SPE is not
labeled "standby" on the status system form after this attempt, use the
busyout spe-standby and release spe-standby command to put the
standby into standby mode.
8. Repeat the command.
9. Issue the test spe-standby long command.
1029 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
Table 10-410. Test Result Error Codes Associated with the Standby SPE — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page