Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-198BRI-SET, ASAI-ADJ, BRI-DAT
10
BRI XID Test (#628)
This test checks the D-channel connection between the SPE and the endpoint or
adjunct.
2069 ABORT The endpoint has returned an error response to the application message
sent by the switch.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of five times.
2. If the test continues to abort, escalate the problem.
2000 FAIL No loop back activation or deactivation response is received from the
endpoint.
1. Consult the endpoint documentation to determine if ISDN-BRI
Management and Maintenance Procedures are supported. If not
supported, use change station extension command to change the
MIMs Supported? field to "no." Use the busyout station extension
and release station extension commands to busyout and release the
endpoint to resolve any endpoint alarms resulting from failure of this
test.
2. If the endpoint supports these procedures and the test continues to
fail, assume the endpoint is defective and replace it.
2071 FAIL No data is detected on Channel B1 during loop back.
2072 FAIL No data is detected on Channel B2 during loop back.
1. Replace the endpoint and repeat test.
2. If test continues to fail, check the wiring between the endpoint and the
switch and repeat the test.
3. If test continues to fail, escalate the problem.
PASS The endpoint has responded to the switch activate and deactivate loop
back application messages. Data has been detected on the looped back
channels.
1000 ABORT Could not seize the endpoint or B-channels for test.
1. Retry the command at one-minute intervals a maximum of five times.
2. If the test continues to abort, escalate the problem.
Table 10-70. TEST #627 BRI Remote Loop Back — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page