Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Error Messages
Page A-137test signaling-group
A
If the standby SPE is not refreshed and the active SPE is hard selected via the SPE
select switches when this command is executed, then the following message is
displayed:
Active SPE locked via select switches;
Standby SPE memory not refreshed
If the standby SPE is busy with another task, then the following message is displayed
Standby SPE busy with another task;
for information use "status system 1"
If the standby SPE is not available when this command is executed, then the following
message is displayed:
Standby SPE not available;
for information use "status system 1"
test signaling-group
Help Messages
If the system technician presses HELP after entering "test signaling-group", the following
is displayed:
Enter group identifier (1-8), [’long’ or ’short’],
[’repeat’ (1-100) or ’clear’], [’schedule’]
Error Messages
If the specified group identifier is non numeric or out of range, the following message is
displayed:
Signaling group invalid
If the specified group identifier is not administered, the following message is displayed:
No signaling group assigned
If no tests can be found for the associated MO, the following message is displayed:
No tests for this MO
If the software data cannot be sent to the SAT, the following message is displayed:
Error encountered, can’t complete request
If during the execution of a command a resource problem occurs that requires the user
to restart the command, then the following message is displayed:
Command resources busy;
Press CANCEL to clear, and then resubmit