Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-642EXP-INTF (Expansion Interface Circuit Pack)
10
1421 ABORT This abort code is valid and can appear only when the Expansion Interface
circuit pack addressed in the test command is one which terminates the link
between two the EPNs. It indicates that the test failed, but that this test was
run on the EPN EI circuit pack that:
a. is in the same EPN as the circuit pack under test,
b. is on the active link and
c. terminates the fiber from the PPN.
The EI tested is probably not at fault.
1. Enter display alarms and follow the EXP-INTF repair procedures for the
EPN EI that:
a. is in the same EPN as the circuit pack just tested here
b. is on the active link, and
c. terminates the fiber from the PPN.
2. If there are no alarms logged against that EI, run Test #589 on it and
follow procedures for this test.
3. Try this command again.
2060 ABORT The link on the Packet Bus that is being used to perform the test has failed.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, check for problems with the Packet Control
circuit pack (look for PKT-CTL errors).
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2500 ABORT An internal operation failed; the test could not be completed.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Table 10-216. TEST #589 Expansion Interface Packet Interface Test
— Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page