Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Error Messages
Page A-83set vector
A
set vector
Help Messages
If the system technician presses HELP after entering "set vector" on a simplex system, the
following message will be displayed:
Enter a memory dump vector value: (0-F)
The memory dump vector value is a hex value representing restart levels
A hex value of ’1’ causes memory dumps to be taken on WARM restarts
A hex value of ’2’ causes memory dumps to be taken on COLDII restarts
A hex value of ’4’ causes memory dumps to be taken on COLDI restarts
A hex value of ’8’ causes memory dumps to be taken on REBOOT restarts
All other hex values represent a combination of restart levels.
The combination is determined by adding the hex values of the individual
restarts together (e.g. a hex value of ’3’ causes memory dumps to
be taken on WARM and COLDII restarts, a hex value of ’F’ causes memory
dumps to be taken on WARM, COLDII, COLDI, and REBOOT restarts, etc.)
If the system technician presses HELP after entering "set vector" on a duplex system, the
following message will be displayed:
Enter a memory dump vector value: (0-F),
[’spe-active’, ’spe-standby’, ’spe-maint’]
The memory dump vector value is a hex value representing restart levels
A hex value of ’1’ causes memory dumps to be taken on WARM restarts
A hex value of ’2’ causes memory dumps to be taken on COLDII restarts
A hex value of ’4’ causes memory dumps to be taken on COLDI restarts
A hex value of ’8’ causes memory dumps to be taken on REBOOT restarts
All other hex values represent a combination of restart levels.
The combination is determined by adding the hex values of the individual
restarts together (e.g. a hex value of ’3’ causes memory dumps to
be taken on WARM and COLDII restarts, a hex value of ’F’ causes memory
dumps to be taken on WARM, COLDII, COLDI, and REBOOT restarts, etc.)
Error Messages
If the format of the condition (dump vector value) is invalid, the following message will be
displayed:
Entry invalid; please press
HELP
If the command entered is in conflict with another currently executing command, then a
message will be displayed showing the login id of the conflicting user and the conflicting
command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the user
to restart the command, then the following message will be displayed: