Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1243TAPE (Tape Unit) [G3iV1.1-286]
10
Tape DMA Latch Test (#230)
Also known as the
Tape Interface Test
, this test checks the shared RAM on the
TN770 Memory circuit pack. The test also checks the communication paths on
the TN773 Processor circuit pack.
Table 10-429. TEST #69 Status Request Test
Error
Code
Test
Result Description/ Recommendation
1029 to
2051
ABORT Refer to the STBY-SPE (Standby SPE) Maintenance documentation for a
description of these error codes.
9000’s ABORT Refer to Table A in ‘‘
Tape Unit Aux Data/Error Codes Tables’’ and follow
the recommended repair strategy for specific Aux Data.
Any
Others
FAIL Refer to Table B in ‘‘
Tape Unit Aux Data/Error Codes Tables’’ and follow
the recommended repair strategy for specific Aux Data.
PASS This test verifies the basic communication between the Processor and the
Tape Drive circuit pack.
Continued on next page
Table 10-430. TEST #230 DMA Latch Test
Error
Code
Test
Result Description/ Recommendation
1029 to
2051
ABORT Refer to the STBY-SPE (Standby SPE) Maintenance documentation for a
description of these error codes.
23001 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of five times.
2. If the test continues to abort, escalate the problem.
23002 to
23005
FAIL Hardware not responding.
1. Follow the instructions provided in the ‘‘
Tape Maintenance and Repair
Procedures’’ section.
Continued on next page