Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-191reset interface
8
reset interface
This command resets the Processor Interface circuit pack, reads its associated
software from tape, restarts applications processes, re-establishes permanent
switched calls, and sets up each enabled link. If the interface cannot be
established, a Major alarm raises on the interface and all enabled links
deactivate. When the Message Server Adjunct (MSA), Distributed
Communications System (DCS), Audio Information Exchange (AUDIX), or Call
Management System (CMS) are initially administered, links for these applications
and submitting the form restarts the interface. Before Processor Interface circuit
packs are replaced, technicians must power down the switch and restart it.
(unless the system is equipped with High or Critical Reliability)
For troubleshooting, see status interface, status link, and status
processor-channel commands to locate problems before performing a reset
interfaces. (link traffic is interrupted)
!
WARNING:
The interface command interrupts operation of the AP, DCS, AUDIX, CMS
or ISDN-PRI.
Alt. Name
Alternate way to identify maintenance objects.
If the Object is The field contains
station extension
trunk
xxx/yyy
(where
xxx
= trunk group number
and
yyy
= member number)
private CO line
P/xxx
(where
xxx
= private CO line group number)
Result
Success status of a busied out object (PASS, ABORT, FAIL)
Error Code
System-generated description of a command failure.
Action/Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
reset interface
location
(cabinet-carrier-position) of the
processor interface (PI board). The
position determines cleared
processor interface circuit pack.
first processor interface = 1
second processor interface = 2
Examples:
reset interface 01a1
reset interface a2
reset interface 01b1
reset interface 01b2
init
inads
craft
none none