Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-835MODEM-PT (Modem Pool Port)
10
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service
due to TDM-BUS errors. Refer to TDM-BUS (TDM Bus) Maintenance
documentation to diagnose any active TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy
traffic, repeat the test at one minute intervals a maximum of five
times.
2. If the test continues to abort, escalate the problem.
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present or some
Tone Detectors may be out-of-service.
1. Look for TTR-LEV errors in the Hardware Error Log. If present, refer
to TTR-LEV (TTR Level) Maintenance documentation.
2. Look for TONE-PT errors in the Hardware Error Log. If present, refer
to TONE-PT (Tone Generator) Maintenance documentation.
3. If neither condition exists, retry the test at one minute intervals a
maximum of five times.
4. If the test continues to abort, escalate the problem.
1004 ABORT The port has been seized by a user for a valid call. Determine whether
the port is available for testing.
1. Retry the command at one minute intervals a maximum of five
times.
2. If the test continues to abort, escalate the problem.
1020 ABORT The test did not run due to a previously existing error on the specific
port or because of a more general circuit pack error.
1. Examine the Hardware Error Log for existing errors against this port
or the circuit pack, and attempt to diagnose the previously existing
errors.
2000 ABORT A response to the test request was not received within the allowable
time period.
1. Retry the command at one minute intervals a maximum of five
times.
2. If the test continues to abort, escalate the problem.
2100 ABORT System resources required for this test are not available.
1. Retry the command at one-minute intervals a maximum of five
times.
2. If the test continues to abort, escalate the problem.
Table 10-278. TEST #96 Modem Pool NPE Crosstalk Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page