Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-405upgrade software
8
Disabled Objects
All disabled objects retain their “disabled” status after a software upgrade
according to the status recorded in the last save translation command.
Output
The following is the output from the upgrade software command and a
successful simplex upgrade.
Explanations and error recoveries to the above steps follow:
INITIATING SOFTWARE
UPGRADE:
The system is upgrading the software.
MEM-CARD CHECKSUM: If the card-mem checksum fails, the system reboots
without performing the upgrade. Retry the command with
another software card-mem.
REPROGRAMMING MTP: If the MTP programming fails, the Manager I does not
function anymore, meaning that the rest of the upgrade (if
it occurs) are not visible and the MTP will not be present to
monitor the health of the processor. The only recovery
procedure is to power down and power up the system,
since the presence of a software card-mem will cause a
software upgrade.
ERASING MEMORY: The rest of the memory is being erased.
REPROGRAMMING SPE: This shows the status of the reprogramming. A total of 7
Mbytes has to be reprogrammed. If the reprogramming
fails in the midst of upgrade, it will take the system into
SPE-down
mode. In this mode, the system technician can
only reset the system or display alarms. The system
should be reset and another upgrade attempted due to
the detection of a software card-mem in the system.
INITIATING SOFTWARE UPGRADE
MEM-CARD CHECKSUM PASSED
REPROGRAMMING MTP PASSED
ERASING MEMORY PASSED
REPROGRAMMING SPE PASSED
FLASH TEXT CHECKSUM PASSED
UPGRADE COMPLETE
<beep>
REPLACE SOFTWARE MEM-CARD WITH TRANSLATION MEM-CARD
<beep>