Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1230SYSTEM (System)
10
SYSTEM (System)
SYSTEM is generally used when software encounters a problem with either
hardware or itself and requests a restart to clear the problem. For example, if
there is a loss of clock in a system with high or critical reliability, the system asks
for a Reset 2 to switch to the other clock. SYSTEM also logs errors that cannot be
associated with any single process. This is not a problem. The initcauses log
should also confirm that a software-requested restart was performed.
Error Log Entries and Test to Clear Values
The Aux Data field may be 0 or the return code from a bad software call, and the
following examples in no way exhaust the possibilities. Often, two errors are
logged at the same time for each problem.
1. SYSTEM only has errors associated with it and thus only appears in the Error Log
and not in the Alarm Log. There are no tests that can be run with SYSTEM.
1. Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
MO Name (in
Alarm Log)
Alarm
Level Initial Command to Run
1
Full Name of MO
SYSTEM None None SYSTEM
Table 10-425. System Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
0 Any Any Any None
8 (a) 0 None
9 (b) Any None
10 (c) Any None
21 (d) None
355 (e) Any None
356 (f) Any None
601 (g) None
602 (h) None
603 (i) None
9012 (j) Any None