Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Routine Maintenance Procedures
Page 5-17System Backup
5
5. If the system is equipped with a TN750 Announcement circuit pack, the
recorded announcements can be saved using the save announcement
commands. Enter the command and press
Enter. The following display
appears:
Screen 5-2. Save Announcements Screen — SPEA
6. Verify that the command successfully completes. If not, an error message
appears. In such a case, refer to the “Translation Card Errors” section.
7. Remove the backup translation card and insert the original translation
card.
8. Label the backup translation card with the date and time it was updated. A
special notation on the card clearly distinguishes it from other cards.
9. Store the backup translation card in a secure place.
Translation Card Errors
Translation card-related failures may occur for two reasons: the card is at fault, or
the Netcon circuit pack is at fault. The following is a list of the error messages
and recommended responses to each.
1. Cannot access file storage area—Implies that the wrong
translation card may be installed.
Response:
Check to see which translation card is installed. If the correct
one is installed, test it.
2. Cannot turn on 12 volt power supply—Implies that something
may be wrong with the Netcon circuit pack, which contains the power
supply.
Response:
Test the 12-volt power supply by entering the test card-mem
command from the terminal. Executing this command causes the system
to run Test 701 (12 Volt Power Supply Test). If the power supply test fails,
replace the Netcon circuit pack. Then repeat whichever command failed.
save announcements
SAVE ANNOUNCEMENTS
Processor Command Completion Status Error Code
SPE_A Success 0
Command successfully completely
enter command: