Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-874M/T-ANL (Maintenance/Test Analog Port)
10
Table 10-295. TEST #963 Analog Port Sanity Test
Error
Code Test Result Description/ Recommendation
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT System resources required to run this test are not available.
2500 ABORT An internal operation failed; the test could not be completed.
1. Retry the command at 1 minute intervals a maximum of 3 times.
2. If the test continues to fail, escalate the problem.
50 FAIL The switch was unable to communicate with the port circuitry used for
analog trunk testing.
1. Reset the circuit pack via the busyout board PCSS, reset board
PCSS, release board PCSS command sequence.
2. Test the port again via the test port PCSS01 l command.
3. If the test fails again, replace the circuit pack.
PASS The Maintenance/Test Analog Port analog trunk testing capability is
operating correctly.
Continued on next page