Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Error Messages
Page A-18clear interface
A
Error Messages
If the command entered is in conflict with another currently executing command, then a
message will be displayed showing the login id of the conflicting user and the conflicting
command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the user
to restart the command, then the following message will be displayed:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the following
message will be displayed:
All maintenance resources busy; try again later
clear interface
Help Messages
If HELP is pressed after entering "clear interface," the following message is displayed:
Enter location: [cabinet(1)], carrier(A-B), pos(1-2)
Error Messages
If the specified carrier is not the active PE, the following message is displayed:
Command must be executed from active SPE
If the cabinet and carrier is invalid for a PPN, the following message is displayed:
Invalid port-network specified
If the carrier is not a valid carrier, the following message is displayed:
Invalid carrier specified
If the technician-entered carrier is not active, the following message is displayed:
Board invalid
If there is not a PI circuit pack administered for the specified position, but the specified
carrier is active, the following error message is displayed:
Processor Interface (TN765) not started or is being started
If the command entered is in conflict with another currently executing command, then a
message is displayed showing the login id of the conflicting user and the conflicting
command. The message is as follows:
’login id’:’command’ has a command conflict