Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1038PR-MAINT (Maintenance Processor [TN790 RISC Systems])
10
MTP Reset Test (#101)
This test is destructive.
The test resets the Maintenance Processor. The destructive nature of this test
causes the following:
■ System Access Terminal to log off
■ DCE port to terminate data transmission
■ Any current memory card access to terminate and also to tear down any
remote access INADS connection
Table 10-354. TEST #101 MTP Reset Test
Error
Code
Test
Result Description/ Recommendation
100 ABORT The requested test did not complete within the allowable time period.
1. Retry the command.
1029
2014
2015
2016
2017
2018
2020
2022
2024
2025
2051
ABORT Refer to “STBY-SPE” for a description of these error codes.
2500 ABORT Internal system error
1. Retry at 1-minute intervals a maximum of 5 times.
1196 FAIL The MTP did not respond to being reset.
1. Retry at 1-minute intervals a maximum of 5 times.
2. If the test continues to fail, replace the Processor circuit pack.
1197 FAIL The Maintenance Processor was reset, but it responded with a NOT PASS
status, indicating that it did not pass initialization correctly. The MTP is not
functioning correctly. The system continues to function. Environmental
monitoring is lost, as is communication with the Standby Processor.
1. Retry at 1-minute intervals a maximum of 5 times.
2. If test continues to fail, replace the Processor circuit pack.
Continued on next page