Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-836MODEM-PT (Modem Pool Port)
10
6000 ABORT System resources needed to complete the test could not be allocated
for the digital section of the Modem Pool conversion resource.
Ordinarily, this means the conversion resource or other hardware used
during the test was in use.
1. Wait one minute and attempt the test again.
2. If it is absolutely necessary to test the conversion resource, the call
must be dropped by issuing a busyout port PCSS command
against the conversion resource. Issue the release port PCSS
command. The busyout and release of the port drop any existing
calls on that port.
3. Run the test again.
4. If the same error occurs while the conversion resource is idle,
busyout and release both Modem Pool conversion resources on
the TN758 Pooled Modem circuit pack containing the conversion
resource under test. This action drops any existing calls on that
circuit pack.
5. If the test continues to abort, replace the Pooled Modem circuit
pack and retest.
6. If the test continues to abort with this error code after circuit pack
replacement, escalate the problem.
6001 ABORT System resources needed to complete the test could not be allocated
for the analog section of the Modem Pool conversion resource.
1. Follow the test procedures for the previous error code.
NONE FAIL The test failed. This error is internal to the Pooled Modem circuit pack
and does not involve external equipment or interfaces.
1. Busyout both of the TN758 Pooled Modem conversion resources
on the circuit pack containing the failing conversion resource.
2. If the test continues to fail, replace the Pooled Modem circuit pack
and retest.
3. If the circuit pack fails after replacement, escalate the problem.
ANY FAIL The NPE of the tested port was found to be transmitting in error. This
condition causes noisy and unreliable connections.
1. If the remaining ports are currently not in use (that is, yellow LED is
off), attempt to reset the circuit pack. Then repeat the test.
2. If the test fails again, replace the circuit pack.
PASS The port is correctly using its allocated time slots. User-reported
troubles on this port should be investigated using other port tests and
by examining station, trunk, or external wiring.
Table 10-278. TEST #96 Modem Pool NPE Crosstalk Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page