Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-96ANN-BD (Announcement Circuit Pack)
10
0-256 FAIL Test failed. The error code indicates the total number of defective
announcements that were found.
When TEST #209 fails with error code 0, the Global Checksum failed on
the board, but no individual Checksum failed.
NOTE:
Since the announcements are recorded digitally, it is possible for
the Announcement Checksum Test to
fail
but still have all the
announcements sound uncorrupted. When an individual
announcement fails the Checksum Test, always listen to the
announcement first before taking any action (an announcement can
be played back by dialing the announcement extension associated
with the announcement number). If the announcement sounds
corrupted, then rerecord it or delete it.
1. Look in the Error Log to determine the number of the first defective
announcement. Play back the announcement. If the announcement
sounds defective, rerecord it or delete it. If the error code was greater
than one (indicating that there is more than one defective
announcement), run this test again and repeat this step.
2. If after deleting and rerecording all defective announcements, the
checksum test still fails, reset the circuit pack using the reset board
PCSS command and run this test again.
3. If the test still continues to fail, reseat the circuit pack and restore all
announcements with an appropriate time estimate (for example, 40
minutes.) Then rerecord the lost announcements (that is, those
recorded since the last save operation) and run this test again.
4. If the test still continues to fail, replace the circuit pack, and run this
test again.
!
WARNING:
Replacing the circuit pack results in loss of integrated
announcements. See "General Notes" near the beginning of this
Maintenance procedure.
PASS All recorded announcements checksum correctly, indicating that the
speech main memory is functioning properly. User-reported troubles on
this circuit pack should be investigated using other circuit pack and port
tests. Refer to "ANN-PT (Announcement Port)" Maintenance
documentation for a description of the port tests.
Table 10-35. TEST #209 Announcement Checksum Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page