Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Error Messages
Page A-146upgrade software
A
If the software card-mem is not inserted in the active SPE within 2 minutes after the
prompting string: "REPLACE TRANSLATION CARD-MEM ON <active carrier> WITH
SOFTWARE CARD-MEM," the command has to be retried again and the following
message will be displayed:
No software card-mem inserted in active SPE; command aborted
If the SPE-select switches are thrown to prevent the SPE-interchange during a software
upgrade, the following message is displayed:
SPE select switches thrown; upgrade complete only on standby
If the standby SPE is not in the standby mode and is busy running tests, the following
message will be displayed:
Standby SPE busy with another task;
for information use ’status system’
If the standby SPE has not completed initialization, the following message will be
displayed:
Standby SPE memory not refreshed; Use ’refresh spe-standby’
If the active SPE cannot communicate with the standby SPE after the standby SPE is
properly upgraded, the following message will be displayed:
Upgrade failed; no communication with
standby after new software booted
If the SPE-interchange failed and the new software cannot be run in the active SPE, the
following message is displayed:
Software upgrade failed, could not perform an interchange