Lucent Technologies lucent Server User Manual


  Open as PDF
of 2392
 
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-551DTMR-PT [Dual Tone Multifrequency Port (TTR)]
10
Tone Detector Audit/Update Test (#43)
The DTMR port is refreshed with all time slot information and sanity audit is
performed on the DTMR port.
1003 ABORT The system could not allocate a Tone Generator for the test connection.
This could happen when the system is heavily loaded or there is not a
Tone-Clock circuit pack in the port network when this test is being
executed.
1. Make sure there is a Tone-Clock circuit pack in the same port network.
2. If a Tone-Clock circuit pack is missing, install one in the same port
network.
3. Allow about one-minute for the Tone-Clock maintenance to run on the
newly inserted Tone-Clock circuit pack.
4. Retry the command at one-minute intervals a maximum of five times.
5. If the test continues to abort, escalate the problem.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of five times.
2. If the test continues to abort, escalate the problem.
2006 ABORT DTMF detection failed. This could be caused by the administered
companding mode of the system not matching that of the Tone Detector
circuit pack.
1. Make sure that companding mode of the system matches that of the
Tone Detector.
2. If the test continues to abort, escalate the problem.
1-3 FAIL DTMF digits were not correctly detected.
1. Run the Short Test Sequence: test port PCSSpp sh r 1.
2. If the problem persists, the system is still operating properly but
system capacity will be reduced. In order to restore the system
performance to normal, replace the Tone Detector circuit pack
containing the defective DTMR port.
PASS The DTMR port is able to detect all the touch-tone digits.
Table 10-183. TEST #42 Tone Detection Verification Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page