Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-309status system
8
maint/
save~announce
SPE in maintenance mode and currently executing a save
announcement command.
maint/status SPE in maintenance mode and currently executing a status
card-mem command.
maint/patching SPE in maintenance mode and currently applying a software
patch to the standby SPE memory.
maint/periodic SPE in maintenance mode and currently performing periodic
background maintenance (performed every two hours if some
component of the standby SPE is alarmed).
maint/scheduled SPE in maintenance mode and currently performing daily
scheduled background maintenance.
maint/analysis SPE in maintenance mode and currently performing
background maintenance testing in response to a reported
trouble by some component in the active or standby SPE
complex that relates to the standby SPE.
maint/upgrade SPE in maintenance mode and currently performing a
software upgrade.
Down Modes
2
down/bad_upgrade SPE in down mode (software upgrade attempt failed). The
standby SPE remains in down mode until a successful
software upgrade is performed.
down/idle SPE in down mode, however, no maintenance activity is
currently taking place. The active SPE could be either active
or selected.
down/entering SPE in down mode, but is currently trying to restart the switch
software on this SPE. As soon as the switch software on this
SPE finishes its initialization, the standby SPE is ready to
perform background or SAT requested maintenance activity.
down/mismatch_
soft
SPE in down mode because the software vintage in flash
memory of the standby SPE does not match the vintage in the
active SPE. The standby SPE remains in down mode until a
successful software upgrade is performed.
down/testing SPE in down mode attempting to execute a test command.
down/
not-refreshed
SPE in down mode executing a destructive background
maintenance test that has temporarily left the standby memory
not refreshed. After the current test finishes, background
maintenance refreshes the standby SPE.
down/analysis SPE in down mode and currently performing background
maintenance testing to determine if the problem has been
corrected.