DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1566XXX-BD (Common Port Circuit Pack)
10
2000 ABORT Response to the request was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
ABORT Could not allocate the necessary system resources to run this test. Internal
System Error.
1. If Error Type 1538 is present in the Error Log, follow the recommended
maintenance strategy.
FAIL The test failed because no neon current was detected.
1. Determine if there is a TN755 or TN752 power unit circuit pack
installed in the same carrier as the TN746 or TN769 analog line circuit
pack that failed the test. Look for the failure of test 220 on other TN746
or TN769 circuit packs in the carrier. If test 220 fails on the other circuit
packs, replace the TN755 or TN752 power unit circuit pack.
2. Retry the command again.
3. If the test continues to fail, replace the circuit pack.
4. Retry the command again.
5. If the test continues to fail, escalate the problem.
PASS This circuit pack is a TN746 or TN769 Analog Line circuit pack and the
neon current is detected. This test also returns PASS for circuit packs that
are not TN746 or TN769 circuit packs, but the test is not run on the circuit
pack and the results of this test can be ignored.
any NO
BOARD
This is normal if the test is being done when (a) the circuit pack is not
physically in the system or (b) the system is booting up. Otherwise, there is
some inconsistency between the physical configuration and the data kept
in the system.
1. Verify that the circuit pack is physically in the system.
2. Verify that the system is not in a stage of booting up.
3. Retry the command at one-minute intervals for a maximum of five
times.
4. If the test continues to return NO BOARD, escalate the problem.
Table 10-530. TEST #220 Neon Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page