Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-270CARR-POW (Carrier Port Power Unit) for DC-Powered Systems
10
Figure 10-23. 645B Port Carrier Power Unit for DC-Powered Systems
Port Carrier Power Unit Replacement Procedures
The procedures for replacing a 644A or 645B carrier DC power unit are given
below.
If the port carrier power unit to be replaced is in a control carrier of a PPN
system, refer to the "Removing Power" and "Restoring Power" sections in Chapter
5, "Routine Maintenance Procedures" before replacing the port carrier power
unit. To replace the port carrier power unit, follow the procedure below:
1. If this is a 645B power unit, set the power switch to OFF.
2. Unplug the power cord.
3. Move the locking slide on the power unit to the extreme left position, and
unlatch the locking lever.
4. Remove the power unit from the carrier.
5. Move the locking slide on the replacement power unit to the extreme left
position and open the locking lever.
STATUS
LOCKING
LEVER
LOCKING
SLIDE
POWER
CORD
OUTLET
ON
OFF
LEDS
RED
AMBER