Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-838MODEM-PT (Modem Pool Port)
10
1020 ABORT The test did not run due to a previously existing error on the specific
port or because of a more general circuit pack error.
1. Examine the Hardware Error Log for existing errors against this port
or the circuit pack, and attempt to diagnose the previously existing
errors.
2000 ABORT The response to the test request was not received within the allowable
time period.
2012 ABORT Internal System Error.
2100 ABORT System resources required for this test are not available.
2103 ABORT The system could not make the conference connection for the test.
1. Retry the command at one-minute intervals a maximum of five
times.
2. If the test continues to abort, escalate the problem.
4000 ABORT System resources needed to complete the test could not be allocated.
Ordinarily, this means the conversion resource or other hardware used
during the test was in use.
1. Wait one minute and attempt the test again.
2. If it is absolutely necessary to test the conversion resource, the call
must be dropped by issuing a busyout port PCSS command
against the conversion resource. Issue the release port PCSS
command. The busyout and release of the port drop any existing
calls on that port.
3. Run the test again.
4. If the same error occurs while the conversion resource is idle,
busyout and release both Modem Pool conversion resources on the
TN758 Pooled Modem circuit pack containing the conversion
resource under the test. This action drops any existing calls on that
circuit pack.
5. If the test continues to abort, replace the Pooled Modem circuit
pack and retest.
6. If the test continues to abort with this error code after circuit pack
replacement, escalate the problem.
Table 10-279. TEST #97 Modem Pool Conference Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page