Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-227status bri-port
8
Output
The following example shows the output from the status bri-port 1c1701
command.
Field descriptions
Port:
ISDN-BRI port address.
Service State:
ISDN-BRI port is "in-service" or "out-of-service."
Maintenance Busy?:
specifies if maintenance testing is executing on the ISDN-BRI
port ("yes" or "no").
Layer 1 State:
BRI Layer 1 (physical) state on the port. Valid states are
"activated," "pend-activation," and "deactivated."
■ "activated" state = layer 1 frames are passing between the
port and BRI endpoints.
■ "pend-activation" state = the port is in-service, the layer 1
interface device is on, layer 1 frames are sending to the BRI
endpoints connected to this port, but BRI endpoints are not
responding.
■ "deactivated" state = the layer 1 interface device on the BRI is
off, because the port goes out-of-service.
TEI Value
Layer 2 addressing parameter used by the switch to exchange
information over point-to-point signaling links between BRI
endpoints. Each point-to-point signaling link has an associated
TEI. This field displays the addressing parameter value. (0–127)
status bri-port 1c1701 Page 1 of 1 SPE A
STATUS BRI-PORT
Port: 01C1701
Service State: in-service
Maintenance Busy?: no
Layer 1 State: activated
TEI Value Layer2 State Endpt Extension Endpt SPID Service SPID?
Link1 64 13-established 1010 1010
Link2
Link3