Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-91ANN-BD (Announcement Circuit Pack)
10
h. Error Type 513This error, when reported with Aux Data in the range of
4352 to 4358, indicates the circuit pack has reported a hardware failure on
the circuit pack. The circuit pack should be replaced.
!
WARNING:
Replacing the circuit pack results in loss of integrated
announcements. See "General Notes" near the beginning of this
Maintenance procedure.
i. Error Type 1025This error is not service-affecting and no action is
required.
j. Error Type 1281
The SP found a fault in the speech main memory (SMM)
(that is, it found one or more faulty memory locations). Whenever this error
is logged, error 2817 is also logged [see Note (k)], which causes the
maintenance system to run the Announcement Checksum Test (#209) to
determine if the bad memory location was being used by an
announcement.
k. Error Type 1538
The hyperactive circuit pack is out-of-service and may
exhibit one or more of the following symptoms:
1. The tests run on the ports of this circuit pack are returning with a
NO-BOARD.
2. A busyout/release of the circuit pack has no effect on test results.
3. A list configuration command shows that the circuit pack and
ports are properly installed.
The system tries to restore the circuit pack within 15 minutes. If the error
recurs after 15 minutes, replace the circuit pack. (Refer to Chapter 5,
"Routine Maintenance Procedures".)
l. Error Type 2049 and 2817
These errors are logged in conjunction with
Error Type 1281, Aux Data 17699. Since that error [see Note (j)] means
that a defective speech memory location was found, the announcement
checksum error is also logged. This causes the Announcement Checksum
Test (#209) to run, which determines if the defective memory location has
corrupted any recorded announcements. If the Checksum Test passes,
the faulty memory location is currently not being used, and the SP marks
the location as faulty to ensure that future announcements do not attempt
to use it.
NOTE:
As memory locations are marked faulty, the amount of available
memory decreases, which decreases the total amount of
announcement time available on the circuit pack.
m. Error Type 2049
A transient error that does not cause an alarm can
occasionally occur during a SPE, TDM BUS, or Tone Clock interchange. It
is possible for a marginal Tone-Clock circuit pack to cause this error