Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1426TSC-ADM (Administered Temporary Signaling Connections)
10
1147 ABORT The ADMTSC is being torn down.
1. Issue the status tsc-administered command at one-minute intervals a
maximum of three times.
2. If ADMTSC is still down, disable and enable the ADM TSC via the
change sig-group <group> command. NOTE: To disable the
ADMTSC, display the (administration) Signaling Group Form via the
change sig-group <group> command where <group> refers to the
number of the signaling group under which the suspect TSC is
administered. Change the Enable field to "n." To enable the ADMTSC,
change the "Enable" field to "y."
3. If the ADMTSC is still down, check the other nodes in the network. If
the ADMTSC is still down, escalate the problem.
1148 ABORT The ADMTSC is enabled, but inactive (near-end).
1. Disable and enable the ADMTSC.
2. Reissue the test tsc-administered command.
3. If the ADMTSC is still inactive, check the other nodes in the network.
1149 ABORT The ADMTSC is disabled.
1. Enable the TSC, and see if the status indicates "active."
2. Reissue the test tsc-administered command.
3. If the TSC still disabled, remove the ADMTSC from the system.
1181 ABORT Ran out of ADMTSC resources.
1. Reissue the test tsc-administered command at one-minute intervals a
maximum of three times.
2. If test continues to abort, escalate the problem.
1182 ABORT The BX.25 link is down at the gateway.
1. Disable the ADMTSC.
2. Check the status of the gateway link via the status link link-no
command.
3. Once the gateway link indicates an "in-service" state, enable the
Administered TSC.
4. Reissue the test tsc-administered command.
5. If the test still aborts, escalate the problem.
Table 10-487. TEST #604 TSC Hartbeat Inquiry Test
Error
Code
Test
Result Description/ Recommendation
Continued on next page