Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-886M/T-DIG (Maintenance/Test Digital Port) [G3iV1-1.286, G3iV2-386]
10
Table 10-299. TEST #161 Loop Around Test
Error
Code
Test
Result Description/ Recommendation
1000 ABORT One of the Maintenance/Test Digital Ports is busy with background
maintenance.
1. Either wait for the port to become idle, or busyout both
Maintenance/Test Digital Ports on the Maintenance/Test circuit
pack via the busyout port PCSS02 and busyout port PCSS03
commands, respectively.
2. Release the ports (if they were busied out) via the release port
PCSS02 and release port PCSS03 commands, respectively.
3. Retry the command at one-minute intervals a maximum of five
times.
4. If the test continues to abort, escalate the problem.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service
due to TDM-BUS errors. Refer to the TDM-BUS Maintenance
documentation to diagnose any active TDM Bus errors.
1. If the system has no TDM-BUS errors, and if not handling heavy
traffic, repeat the test at one-minute intervals a maximum of five
times.
2. If the test continues to abort, escalate the problem.
1004 ABORT The port was seized by a valid ISDN-PRI Test Call. Use the list
isdn-testcall command to determine which call is using the port (from
the M/T Port column). Either wait for the test call to complete (as
indicated in the Start Time and Duration fields of the above display), or
abort the test call with the clear isdn-testcall tg/mem command, where
tg/mem is determined from the B-channel field of the above display.
1019 ABORT An ISDN Test Call is in progress using this Maintenance/Test circuit
pack. The Maintenance/Test circuit pack cannot perform a self-test on
one of its Digital Ports while an ISDN Test Call is using either of the
Digital Ports. Use the list isdn-testcall command to determine which
call is using the port (form the M/T Port column). Either wait for the test
call to complete (as indicated in the Start Time and Duration fields of the
above display), or abort the test call with the clear isdn-testcall
tg/mem command, where tg/mem is determined from the B-channel
field of the above display.
1. Retry the command at one-minute intervals a maximum of five
times.
2. If the test continues to abort and the port is not in use, escalate the
problem.
Continued on next page