Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-34ADX16D-P (16-Port AUDIX Digital Port)
10
information (data) channel is then performed. This test is the same as the primary
information channel loop around test.
Next, a Conference Test is implemented for the primary information channel. This
test is the same as Conference Test #6.
Only one value (Pass, Fail, or Abort) is generated as a result of the four tests run.
If any test fails or aborts, the sequence is stopped.
Table 10-14. TEST #13 Voice and Control Channel Local Loop Test
Error
Code
Test
Result Description/Recommendation
ABORT Internal System Error (a)
1000 ABORT System resources required to run this test are not available. The port may
be in use. Use the display port PCSSpp command to determine the voice
port extension of the port. Use the status station command to determine
the service state of the port. If the port is in use, it is unavailable for certain
tests. Refer to “Status” commands in Chapter 8, "Maintenance Commands
and Trouble-Clearing Aids" for explanations of all possible states. Wait
until the port is idle before retesting, then try (a).
1001 ABORT System resources required to run this test are not available; try (a).
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots that are
out-of-service due to TDM-BUS errors. Refer to “TDM-BUS” to diagnose
TDM-BUS errors.
1. If the system has no TDM-BUS errors and if it is not handling heavy
traffic, try (a).
1003 ABORT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of tone detectors present, or some tone
detectors may be out-of-service.
1. Resolve any “TTR-LEV” errors.
2. Resolve any “TONE-PT” errors. Try (a).
1004 ABORT The port was put in use during the test. The test has been aborted. Use the
display port PCSSpp to determine the voice port extension of the port.
Use the status station command to determine the service state of the
port. If the port is in use, it is unavailable for certain tests. Wait until the port
is idle before retesting. Try (a).
2000 ABORT Response to the test request was not received within the allowable time
period. Try (a).
2100 ABORT Could not allocate the necessary system resources for this test. Try (a).
Continued on next page