Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-237CARD-MEM (Memory Card)
10
Memory Card Insertion Test (#695)
This test, which is nondestructive, verifies whether a memory card is inserted into
the memory card slot at the TN777B NETCON circuit pack and also whether the
system can detect its existence.
Memory Card Format and Read Test (#696)
This test is a nondestructive test. The memory card must be formatted before an
application. The test reads the directory file from the memory card, and it verifies
the integrity of the directory file.
Table 10-82. TEST #695 Memory Card Insertion Test
Error
Code
Test
Result Description/ Recommendation
2012
2106
2114
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
2013
2100
none
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2108 ABORT The NETCON circuit pack is not a TN777B circuit pack.
1. Follow the Standard Repair Procedures for replacing the NETCON
circuit pack with the TN777B circuit pack.
2. Re-enter the test card-mem command.
FAIL No memory card is inserted in the TN777B NETCON circuit pack, or the
inserted memory card has a bad connection.
1. Insert a memory card into the slot at the TN777B NETCON circuit
pack.
2. If a memory card is already inserted, take the memory card out and
examine the connectors of the memory card and the TN777B
NETCON circuit pack. Insert the memory card into the slot again.
3. When a memory card is pushed into the slot, make sure that the
memory card is inserted firmly into the slot.
4. Re-enter the test card-mem command. If the test still fails, replace the
memory card, and then repeat this step one more time.
5. If the test still fails after you replace the memory card, replace the
TN777B NETCON circuit pack. Follow the Standard Repair
Procedures for a memory card.
PASS A memory card is inserted into the TN777B NETCON circuit pack, and the
system can recognize its existence.
Continued on next page