Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Error Messages
Page A-135test processor
A
If during the execution of a command a resource problem occurs that requires the user
to restart the command, then the following message will be displayed:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the following
message will be displayed:
All maintenance resources busy; try again later
test processor
Help Messages
If the system technician presses HELP after entering "test processor" on a simplex SPE
system the following message will be displayed:
Enter [’long’ or ’short’],
[’repeat’(1-100) or ’clear’], [’schedule’]
If the system technician presses HELP after entering "test processor" on a duplex SPE
system the following message will be displayed:
Enter [cabinet(1)];carrier(A-B),
[’long’ or ’short’],
[’repeat’(1-100) or ’clear’], [’schedule’]
Error Messages
For SPE duplex systems, if no carrier is entered on the command line, the following
message will be displayed:
A carrier must be specified for duplex systems
For any system, if the length of the user entered parameter exceeds three (3), the
following message will be displayed:
Entry invalid
On any system, if any cabinet other than "1" or "01" is specified, the following message
will be displayed:
Only cabinet ’1’ may be specified for this command
If a carrier is entered which is not valid for the current system configuration (for example,
anything other than "A" or "B" for SPE duplex and anything other than the ’a’ carrier for
SPE simplex), the following message will be displayed:
Carrier out of range;
Enter ’a’ if SPE simplex, ’a’ or ’b’ if SPE duplex
If the standby SPE was specified, and it does not respond, the following message will be
displayed: