Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Routine Maintenance Procedures
Page 5-27Software Upgrade
5
Enable Customer Options
1. Enter change system-parameters customer-options.
2. Use these forms to verify the customer options are properly set.
NOTE:
In the Basic Call Setup field, if ISDN-PRI? was set to y before the
upgrade, be sure to set the field back to y.
Resolve Alarms
Examine the alarm log. Resolve any alarms that may exist using
DEFINITY
Enterprise Communications Server Release 5.4 Maintenance for R5vs/si
.
Verify Alarm Origination to INADS
Be sure the system is part of the existing INADS database by calling the INADS
Database Administrator at the Technical Service Center (TSC). Verify that INADS
can dial into the system and that the system can dial out to INADS. As part of the
system registration process, the INADS Database Administrator enables Alarm
Origination.
Return Equipment
Return the replaced equipment (including the old Translation Card) to Lucent
Technologies according to the requirements outlined in the following documents:
BCS/Material Logistics, MSL/Attended Stocking Locations
Methods and Procedures for Basic Material Returns
High and Critical Reliability (Duplex) Systems
The upgrade procedure for high and critical reliability systems takes up to two
hours. Service is interrupted for about five minutes. The procedure cannot be
done remotely, and it must be performed at the PPN (local) terminal.
Ensure that the following items are available before proceeding:
1. Generic software card with the software release currently running in the
system
2. Generic software card containing the new software to which upgrades are
to be made
3. Translation cards on which to save system translations (these cards
should already be in the system)
4. Software patch (if it exists) that is currently applied to the system (this
patch is downloaded if a software backout is required)